Hypertherm Shape Cutting Control - Manual (Page 44)

Edge Ti
38
Optional Lifter Assembly
Lifter Assembly Mounting
Mount the lifter assembly on the cutting table. The lifter should be mounted to
take the maximum advantage of the vertical travel range. Typically the bottom of
the lifter should be between 6 and 8 inches above the cutting table. If required
the torch breakaway gap set-screw can be adjusted to change the clamping
force. For normal operation this adjustment is preset at the factory.
NOTE: For reliable operation the ground must be connected.
Torch Magnetic
Breakaway
All Cable
Connections exit top
All Lifter components,
including Motor and
Brake, are fully enclosed