Hypertherm Shape Cutting Control - Manual (Page 56)

Voyager III
50
11 Channel /Z Input
12 Field Common
13 Field Common
14 Servo Output Common
15 Drive Enable Out ( relay contact )
Note: Cable Shields should be connected to chassis ground.
Drive/ Encoder Input Mating Connector
Connector: 15C D-Sub Amp # 25206-3 or equivalent
Backshell: Amp #748676-2 or equivalent
Pins: Amp #5-66506-9 ( 20-24 AWG ) or equivalent
Note: Wiring pattern continues for additional Axes
Analog Connection Pinout
Note on analog connector: For opertional flexibility, inputs and outputs have a
shared logic and are provided in both positive logic (+24VDC) and negative logic
(24VDC common).
In this application shared I/O means that a single I/O assignment is offered at
three locations.
Example: Output 15 could be assigned as the I/O connector a Nozzle Contact
Enable. Once assigned in software, this output signal would be available as:
- A positive logic output on second I/O connector Pin 20
- A positive logic output on analog connector Pin 7
- A negative logic output on analog connector Pin 8
Analog 1
Pin # Designation
Description
1 Analog 1 + Analog Input ( 0-10VDC)
2 Analog 1 - Analog Common
3 +24VDC
4
Duplicate Input 15 Positive logic shared input 15
5 Field Common
6 Alternate Input 15 Negative logic shared input 15
7 Duplicate Output 15 Positive logic shared output 15
8 Alternate Output 15 Negative logic shared output 15
9 Field Common
Note: Wiring pattern continues for Analog 2-6
Assignable shared I/O locations are 15, 16, 31, 32, 47, 48