Hypertherm MAX200 Service Manual - Manual (Page 48)

MAX200 Service Manual 3-7
MAINTENANCE
Sequence of Events
On the following pages is a detailed flow chart outlining the sequence of events during proper MAX200 operation
with a hand or machine torch. Shaded boxes represent action taken by the operator.
The following symbols used in the flowchart are ANSI standard flowcharting symbols. Their names and definitions
are as follows:
Terminus The terminus is used to indicate the beginning
or ending point of a flowchart.
Task/Process The process or task box is used to indicate any
Box
process or task other than an input/output
operation or a decision.
Decision The decision diamond is used to indicate a
Diamond decision or branching point.
Preparation The preparation symbol is used to indicate an
instruction modification.
Off-page The off-page connector is used to indicate exit
Connector or entry from another page to the flowchart.