Ivoclar Vivadent IPS e.max CAD Abutment Solutions - Manual (Page 11)

Preparation for the CAD/CAM process
Scanning
For the fabrication of IPS e.max CAD Abutment Solutions and depending on the CAD/CAM system used,
the clinical situation is digitalized either by a direct intraoral scan or an indirect model scan. For notes
regarding the scan, please observe the manufacturer's instructions for use of the CAD/CAM system.
Selecting a Ti base
The required Ti base is selected depending on the inserted implant and the CAD/CAM system used.
11
Clinical W
orking Steps | Layer Thicknesses | Block Selection | Finishing
– Fabrication Hybrid Abutment and Hybrid Abutment Cr
own