Ivoclar Vivadent IPS e.max CAD Abutment Solutions - Manual (Page 43)

43
– Remove restoration from the furnace after completion of the firing cycle (wait for the acoustic signal of the furnace).
– Allow the objects to cool to room temperature in a place protected from draft.
– Do not touch the hot objects with metal tongs.
Completing the IPS e.max CAD Ceramic Structure
– Staining T
echnique on the T
ooth-Colour
ed Restoration
Optional
Shape adjustments of IPS e.max Ceram Add-On
Use IPS e.max Ceram Add-On Dentin and/or Incisal for shape adjustments after Glaze firing. Please observe the following
procedure for processing:
– Mix IPS e.max Ceram Add-On Dentin or Incisal with IPS e.max Ceram Build-Up Liquid soft or allround and apply on the
corresponding areas.
– Fire with the stipulated parameters for the "Add-On after Glaze firing". Observe long-term cooling!
– If necessary, polish the adjusted areas to a high gloss after firing.
Firing parameters see page 64
next working step … Permanent cementation Ti base / ceramic structure page 46