Kanguru U2D - Manual (Page 29)

27
4.4 BTN. Sound
The BTN. SOUND option allows you to enable or disable the audible tone that sounds when you tap or
hold a button. Tap the ‘RUN’ button to change this option’s setting.
• [ ٭ ] – Button sounds are enabled (default). Tapping a button will be accompanied by a short tone.
Holding a button will be accompanied by a long tone followed immediately by a higher pitched
tone.
• [ ] – Button sounds are disabled. No audible tones will sound when you tap or hold a button.
4.5 Show EXE Time
The SHOW EXE TIME option allows you to enable or disable whether the total execution time for a
function is displayed on the LCD screen. The total execution time will be displayed after a function has
completed. Tap the ‘RUN’ button to change this option’s setting.
• [ ٭ ] – Enabled. The total execution time is displayed.
• [ ] – Disabled (default). The total execution time is not displayed.
4.6 Sel Img File
The SEL IMG FILE function is used for selecting an image file that has been saved either to the internal
hard drive or to a Storage Center.
To select an image file:
1. From the SETUP menu, tap the ‘SET’ button to navigate to the SEL IMG FILE option.
2. Tap the ‘RUN’ button. The digit furthest to the right will be blinking, indicating that it is currently
selected. Tap the ‘RUN’ button to increase the digit by one.
3. Tap the ‘SET’ button to select the next digit to the left. Tap the ‘RUN’ button to increase the digit
by one. Repeat this step as necessary.
4. When you have completed selecting an image file, hold the ‘RUN’ button to confirm your selection.
BTN. Sound / Show EXE Time / Sel Img File