Kanguru U2D - Manual (Page 36)

34
5.12 Format Source
The FORMAT SOURCE function allows you to either:
• Format the internal hard drive (this will erase all data stored on the hard drive)
• Format a USB drive connected to the source port as a Storage Center
Caution! Formatting will erase all data from the USB drive.
To format the internal hard drive:
1. Make sure that the SELECT SOURCE option is set to “H” (see section 4.3 Select Source on page
26).
2. Tap the ‘RUN’ button to format the internal hard drive.
3. You will receive a message asking you to confirm formatting the drive. Tap the ‘RUN’ button to
proceed or tap the ‘SET’ button to cancel.
Caution! Formatting the internal hard drive will erase any saved image files stored on the hard
drive.
To format a USB drive as a Storage Center:
1. Make sure that the USB drive you want to format as a Storage Center is connected to the Source
USB port.
2. Tap the ‘RUN’ button to format the USB drive as a storage center.
3. You will receive a message asking you to confirm formatting the drive. Tap the ‘RUN’ button to
proceed or tap the ‘SET’ button to cancel.
Caution! Formatting the USB drive as a Storage Center will erase any data stored on the device.
5.13 Total Copy Count
The TOTAL COPY COUNT function allows you to view the total number of successful and failed
operations performed on your USB Duplicator. This is a running count that includes all modes. Tap the
‘RUN’ button to view the total copy count.
Format Source / Total Copy Count