Setting the network [network, At “network connecting, When “dhcp” settings is “off”) – Marantz NA-11S1 User Manual

Page 18: Network connecting, Displayed when the “dhcp” setting is “off

Advertising
background image

15

Setting the network [Network]

For details on “Quick Setup” operations, see the separate

“Getting Started”.

If you cancelled “Quick Setup” menu or changed the

network environment, perform “Menu” – “Quick Setup”.

Connecting wired LAN

Use this procedure to configure the wired LAN settings.

n Network connecting

(when “DHCP”settings are “On”)

When using this unit with the broadband router’s DHCP

function enabled, this unit automatically performs the IP

address setting and other settings.

1

Connect the LAN cable

(

vpage  8

“Connecting to a

home network (LAN)” – “Wired

LAN”).

2

Press

X

(on/standby) to turn on

power to the main unit.

3

Press

MENU

.

Turns on the Menu settings mode

and the Menu appears on the

display (

vpage  11

“Menu

map”).

4

Use

ui

and

ENTER

to select “Network” –

“Settings” – “DHCP (On)”, then press

ENTER

or

p

.

“Select DHCP” menu appears.

5

Use

ui

to select “On”, then press

ENTER

or

p

.

“Setup Ethernet” menu appears.

6

Use

ui

to select “Test Connection”, then press

ENTER

or

p

.

“Wait for the network to connect...” is displayed, and

the unit starts connecting to the LAN.

• When the connection is made successfully, “Connected!”

appears.

• If the connection cannot be established, “Connection

Failed” is displayed. Perform steps 1 – 6 again.

You may need to set the network connection manually,

depending on the provider you use. To set the connection

manually, use the setting procedure of “Network connecting

(when “DHCP” settings are “Off”)”.

n Network connecting

(when “DHCP” settings is “Off”)

This section explains the settings when connecting this unit

to a network that does not have a DHCP function.

To configure the settings manually, check the setting details

with your network administrator.

1

Perform steps 1

4 of the

“Network connecting (when

“DHCP” settings are “On”)”

procedure and select “Off” in

step 5.

“Setup Ethernet” menu appears.

2

Use

ui

to select “IP Address”,

then press

ENTER

or

p

.

“Enter IP Address” menu appears.

3

Use

uip

or

0 – 9

to input the

IP address and press

ENTER

.

4

Use

uip

or

0 – 9

to input the address for

“Subnet Mask”, “Gateway”, “Primary DNS”, and

“Secondary DNS”.

5

Use

ui

to select “Test Connection”, then press

ENTER

or

p

.

“Wait for the network to connect...” is displayed, and

the unit starts connecting to the LAN.

• When the connection is made successfully, “Connected!”

appears.

• If the connection cannot be established, “Connection

Failed” is displayed. Perform steps 1 – 5 again.

Preparation

Operation

Information

Preparation

Advertising
This manual is related to the following products: