Resetting the microprocessor, Specifications – Marantz NA-11S1 User Manual
Page 59
56
n Audio performance
• Analog output
Channels:
2 channels
Playable frequency range:
2 Hz – 96 kHz
Playable frequency response:
2 Hz – 50 kHz (–3 dB) (DSD mode,
PCM sampling frequency: 192 kHz)
2 Hz – 20 kHz
(PCM sampling frequency: 44.1 kHz)
S/N:
110 dB (Audible Range)
Dynamic Range:
110 dB (Audible Range)
Harmonic Distortion:
0.001 % (1 kHz, Audible Range)
• Output Level
Unbalanced:
2.3 V RMS Stereo
Balanced:
4.6 V RMS Stereo
Headphone output:
30 mW/32 Ω/ohms (variable maximum)
• Digital output
Coaxial:
0.5 Vp-p
Optical:
–19 dBm
• Digital input
Coaxial:
0.5 Vp-p
Optical:
–27 dBm or later
USB (Front)
USB Type A (USB 2.0 High speed)
USB (Rear)
USB Type B (USB 2.0 High speed)
n Power supply
Power supply voltage/frequency:
AC 120 V, 60 Hz
Power consumption:
50 W
Power consumption in standby mode: 0.4 W
Power consumption in
“Network Control” – “On” mode:
3 W
• For purposes of improvement, specifications and design are subject to change without notice.
Specifications
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values and all
previously stored custom settings will be have to be manually restored.
ENTER
INPUT
1
Pull the power cord out of the power outlet.
2
Plug the power cord into a power outlet while pressing
ENTER
and
INPUT
on the
main unit.
3
When the STANDBY indicator lights, release the buttons.
“Initialized” appears in the display.
If “Initialized” does not display in step 3, start over from step 1.
Preparation
Operation
Information
Information