NavCom RT-3020 Rev.F - Manual (Page 57)

RT-3020 User Guide – Rev. F
4-55
Figure 17: StarUtil Rover Navigation Setup
This port is normally used to output data to other
devices or machines that can make immediate use of
the precise positioning data available from the
RT-3020. COM1 also serves as the DGPS correction
input/output port when NCT RTK/UltraRTK™, CMR,
or RTCM RTK correction services are in use.
„ COM2
9 Configuration - Control Port
9 Rate – 19.2Kbps
This port is normally used to input and output
proprietary messages used for navigation and
receiver setup. Table 9 describes the default
messages needed to best initiate surveying with
minimal effort.