NavCom RT-3020 Rev.F - Manual (Page 77)

RT-3020 User Guide – Rev. F
C ...................... Event Input Configuration
Figure 21 details the wiring of the Event/Can cable
assembly (NavCom P/N 94-310062-3003).
Refer to Chapter 2 Interfacing/Event for detailed
electrical specifications.
Table 12 details the wiring configuration required for
Event-Hi, and Event-Lo pulse sensing.
Figure 21: Event Cable Wiring Diagram
Table 12: Event Wiring Connections
Pin #
Signal
Name
Event Sync Wiring
1 Event-Lo Tie Event-Hi to Ground
2 Event-Hi Tie Event-Lo to Ground
3 Ground N/A
Once the cable is wired to correspond with the event
pulse requirements, configure the receiver to output
the message containing a time mark, referenced to
the time kept within the receiver, indicating when the
event is sensed (xB4).
The Event Input can be triggered on the Rising or
Falling edge of the input pulse. Configuration is
possible thru the StarUtil program. Select Receiver >
Setup > PPS and Event Latch from the menu bar.
C-75