NavCom RT-3020 Rev.F - Manual (Page 78)

RT-3020 User Guide – Rev. F
In StarUtil, enable the Event Latch message (0xB4) in
the NCT Binary Messages output list. Select
Receiver > Messages > NCT output from the menu
bar to open the list. Set the Message Rate for 0xB4 to
On Trigger. Right-Click in the Rate cell for message
B4. Select Other > On Trigger from the menu (see
Figure 23). Once configured, the Event Latch
Message (0xB4) is output upon recognition of an
input trigger by the receiver.
‡
Message 0xB4 is described in the
Technical Reference Manual (see Related
Documents in the fore-matter).
Figure 22: PPS & Event Latch Configuration
The PPS and Event Latch window opens (see
Figure 22).
Figure 23: Event Latch Output Rate
C-76