NavCom StarControl Rev.C User Manual
Page 50
Advertising
StarControl User Guide Rev. C
8 - 48
Chapter 8.............................................................. Rover Configuration
This chapter provides a step-by-step procedure to configure a Rover receiver. Rover is
the default configuration for a NavCom receiver. Between uses the receiver state, Base
or Rover, may be unknown. StarControl sets the receiver, regardless of the actual
current state. The following example assumes a successful connection between
StarControl and the GPS receiver is established.
Create a profile to configure the receiver as a rover, as outlined in Chapter 5
Profiles\Profile tab.
Figure 45: Rover RTK Tab Options
Continued on next page
Advertising