Niveo Professional NWAR33P - Manual (Page 15)

15
The detail instruction in Reset Button
1. Recovery procedures for non-working routers (e.g. after a failed firmware upgrade flash):
Hold the Reset Button on the back of the modem in. Keep this button held in and turn on the
modem. Once power LED show
s orange, release the Reset Button. The modem‟s emergency-
reflash web interface will then be accessible via http://192.168.1.254 where you can upload a
firmware image to restore the modem to a functional state. Please note that the modem will only
respond via its web interface at this address, and will not respond to ping requests from your PC
or to telnet connections.
Before powering on the router to enter the recovery process, please configure the IP address of
the PC as 192.168.1.100 and proceed with the following step by step guide.
1. Power the router off.
2. Hold the "Reset Button”.
3. Power on the router. Then Router's IP will reset to Emergency IP address (Say
192.168.1.254)
4. Download the firmware.
Cabling
One of the most common causes of problems is bad cabling or ADSL line(s). Make sure that all
connected devices are turned on. On the front panel of your router is a bank of LEDs. Verify that
the LAN Link and ADSL line LEDs are lit. If they are not, verify if you are using the proper
cables.
Make sure that all devices (e.g. telephones, fax machines, analogue modems) connected to the
same telephone line as your router have a line filter connected between them and the wall outlet
(unless you are using a Central Splitter or Central Filter installed by a qualified and licensed
electrician), and that all line filters are correctly installed in a right way. If line filter is not installed
and connected properly, it may cause problem to your ADSL connection or may result in
frequent disconnections.