Niveo Professional NWAR33P - Manual (Page 96)

96
IP (0.0.0.0:Auto): Your WAN IP address. Leave the IP address as 0.0.0.0 to enable the device
to automatically obtain an IP address from your ISP.
Auth. Protocol: Default is Auto. Please consult your ISP on whether to use Chap, Pap or
MSCHAP.
Obtain DNS: A Domain Name System (DNS) contains a mapping table for domain name and IP
addresses. DNS helps to find the IP address of a specific domain name. Check the checkbox to
obtain DNS automatically.
Primary DNS: Enter the primary DNS.
Secondary DNS: Enter the secondary DNS.
Connection: Click on Always on to establish a PPPoE session during start up and to
automatically re-establish the PPPoE session when disconnected by the ISP. You may uncheck
the item to disable this function.
Idle Timeout: Auto-disconnect the broadband firewall gateway when there is no activity on the
line for a predetermined period of time.
MTU: Control the maximum Ethernet packet size your PC will send.
MAC Spoofing: This option is required by some service Providers. You must fill the MAC
address specified by your service provider when this information is required. The default setting
is set to disable.
IPv6: Check to enble IPv6 function.
IPv6 Address: Enter the IP address of the default gateway. Default is "::", which obtains IPv6
address automatically.
Obtain IPv6 DNS: Click to activate DNS and to enable the system to automatically detect DNS.
Primary DNS / Secondary DNS: Enter the IP addresses of the DNS servers. The DNS servers
are passed to the DHCP clients along with the IP address and the netmask.