Nortec MH Series - Manual (Page 46)

43 | Start Up
MHTC/B Pre-Start Up Checklist
Unit Serial #: _________________ Tag: _______________
Model: MHTC Reflow  MHTC Flow  MHB 
Customer/Job:
Address:
Water Quality:
 Potable  RO  DI 
Air Conditions
 Air Filters (MERV 8, 11 or better)  Uniform air flow 
 Air Velocity Duct static pressure
 Air temperature before duct unit
Duct Unit Mounting:
 20 in.+ (50 cm)+ from heaters 
 Access door for media removal  Space for media removal 
 Drain pan edges Level  Side panels fastened to walls 
 Sealed between duct wall and unit 
 Water tight section min. 3 ft. past duct module  Corrosion resistant if DI water used 
 Drain downstream from duct module 
 Mist Eliminator if > 750 fpm (3.8 m/s) (yes/no)
MHTC Reflow Hydraulic Unit Mounting:
 Level  Front/Top Clearance  Reservoir below drain pan 
Water / Drain Line:
 Water line size (min. 1/2 in.) Water pressure: 30-80 psig 
 Drain Ø (min. 1 1/4 in. (32 mm) ID Drain lines sloped 
MHTC Reflow Plumbing
 P Trap 6 in. (15 cm) or duct static pressure +2 in. on overflow  Hydraulic unit drain 
 Spray bar lines connected to correct staging valves  No low points 
 Pressure equalization hose connected  No dips/sags in press. equalization hose 
 All hose connections clamped 
MHTC Flow / MHB Plumbing
 P Trap 6 in. (21 cm) or duct static pressure +8 in. on Pan Drain 
 Overflow capped 
 Spray bar lines connected to correct staging valves  No low points 
 All hose connections clamped 
Wiring:
 MHTC Flow and Reflow wiring between control box and hydraulic unit to correct terminals 
 Wiring connections and connectors secured 
Controls:
 Control Location Control to Terminal 4 
 Air proving switch  On/Off controls to Terminal 2 
Power:
 Voltage, amp, fuse per Spec Label: 
 Disconnect switch located close to MH 
Inspected by:
Date of inspection: ______/_______/______
Company: