Quantum Composers 9530 Series - Manual (Page 19)

9530/8530 Manual Version 4.8 Page 19
When in the System Configuration menu only the RS-232 baud rate can be changed, the USB
rate must be varied using the SCPI commands via one of the serial interfaces.
Interface: RS-232, Ethernet, or USB
Baud Rate: Selects the baud rate for the RS-232 serial interface.
Echo: Selects whether the unit will echo characters back to the host
computer or not.
Setting Keypad Parameters
The keypad parameters can be set be entering the system configuration menu, and pressing the
Page button. The rate at which a key will repeat itself when held down may be set. This can be
used to provide a controlled rate at which a parameter is incremented. In addition, the volume of
the beep can be controlled for the keypad.
Key Rate: Sets the rate at which the keys will repeat when held down.
Key Vol: Sets the beep volume for the keypad.
Setting the Auto Start Mode
The auto start feature can be set be entering the system configuration menu, and pressing the
Page button twice. The unit may be configured to automatically start generating pulses after power
up.
Setting the Display Decimal Mark
The display mark feature can be changed be entering the system configuration menu, and pressing
the Page button twice. The unit may be configured to show either a
“.” or a “,” when the parameters
need separation like in the width menus.
Mark:
Selects the format of the decimal mark to either a “.” or a “,”
Setting the Display Brightness
The display brightness feature can be changed be entering the system configuration menu, and
pressing the Page button twice. The unit may be configured to illuminate the display to varying
brightness. Also with a command that can be found in the SCPI command section the display can
be turned off entirely.
LCD: Adjusts the display brightness.