Quintum Technologies Call Routing Server - Manual (Page 18)

P/N 480-0028-00-00 2-7
Chapter 2: Hardware Installation
Install hardware
Before you begin
Once the Call Routing Server is in place, you will need to make only the physical connection between the unit
and the Ethernet hub/switch, as well as plug the unit into an AC outlet. Once connected, you can configure the
unit via Quintum Routing Server Manager software.
System Requirements
Inspect package contents
Before you install the hardware, ensure the following components are included in your shipment.
• Tenor Call Routing Server and mounting hardware
• 1 AC Power Cable
• RJ-45 Ethernet LAN Cable (one or two depending upon your custom configuration)
• CD ROM containing User Documentation
If a listed component is not included in your package, contact your customer service representative.
Pre-installation guidelines
• Inside parts have hazardous voltages. If the cover is removed, your warranty will be void.
• Do not connect equipment in wet conditions or during a lightning storm.
• The area must not exceed any of the environmental limits outlined in Appendix A: Technical Specifica-
tions.
Position the unit
The unit can be installed on a flat surface (i.e., tabletop) or mounted within a rack.
Tabletop Install. The unit can be located on any sturdy, flat surface. If necessary, you can stack up to four
units together. Before locating the unit on a tabletop, read the location guidelines that follow.
WARNING: If installing on a tabletop or any other flat surface, we recommend that you stack no more than
four units together.
Pre-Installation Guidelines
• The surface must be sturdy.
• Avoid exposing the unit to excessive vibrations.
• Keep the unit away from wet or dusty areas.
• The area must not exceed any of the environmental limits outlined in Appendix A: Technical Specifica-
tions.
• Leave at least 3” clearance surrounding the unit.
• Do not cover any of the ventilation holes.