Quintum Technologies Call Routing Server - Manual (Page 19)

P/N 480-0028-00-00 2-8
Chapter 2: Hardware Installation
Locate the unit on a tabletop as follows:
1. Place the unit on a desk, tabletop, or any flat, solid surface.
2. Ensure the unit will not slip or fall from the surface.
3. Ensure the power cord within reach of the power outlet.
Rack Install. The unit can be located in a standard 19” rack. Mounting brackets are attached to the unit; the
rack is not included with your system. (See the documentation that comes with your rack for detailed installa-
tion instructions.)
Pre Installation Guidelines
• The maximum recommended ambient temperature is 40º C (104º F). Internal rack temperature should be
considered for safe operation.
• Do not restrict airflow vents when installing the unit in the rack.
• Mechanical loading of rack should be considered so that the rack remains stable and unlikely to tip over.
• Consider the overall loading of the branch circuit before installing any equipment in a rack environment.
• Ensure that a reliable earthing path is maintained in a rack system. This unit is intended to be connected
to earth ground.
Required Materials
• 19” rack (not included with system)
• #10 - 32 x 5/8 screws (qty: 4) (included with system)
• #10 - 32 clip nuts (qty: 4) (included with system)
• 6 mm x 20 mm screws (qty 4) (included with system)
• 6 mm clip nuts (qty 4) (included with system)
• screws as required by your rack manufacturer
Install the chassis in a rack as follows:
1. Choose a position for the chassis within the rack.
WARNING: If the Call Routing Server is the only equipment installed in the rack, ensure it is level with
the rack to avoid the rack from becoming unbalanced. Ensure the equipment is secured with
four screws.
1. Align the chassis mounting brackets flush with the rack’s mounting holes (see Figure 2-5) and follow the
vendor specific instructions for rack installation. The screws provided require a Phillips #2 screwdriver.
2. Ensure the chassis is secured firmly to the rack.