Configuration, Configuration -3 – Quintum Technologies Call Routing Server User Manual
Page 40
P/N 480-0028-00-00
5-3
Chapter 5: Configure via Command Line Interface (CLI)
Configuration
ether
Description:
Enables you to configure the Ethernet Port IP Configuration, Ethernet Port IP
Address and Ethernet Port Subnet Mask, as well as displays the current Ether-
net Port IP address and Subnet mask already configured.
When the unit is initially shipped, the IP address is set to 0.0.0.0.
Two Ethernet ports are supported: Ether 0: supports 10/00, Ether 1: supports
10/100/1000.
NOTE: Ethernet port 2 is reserved for future use.
Cmd Type:
Command.
Prompt Level:
Main Routing Server prompt.
Syntax:
ether {1|2}. Displays ethernet statistics for the given ethernet port.
ether {1|2} ip {ipaddress}. Standard IP address that you enter for the given eth-
ernet port.
ether {1|2} netmask {netmask}. Standard subnet mask that you enter for the
given netmask port.
Availability:
All Releases of Tenor Routing Server
Examples:
Routing Server> ether0
Routing Server> ether 1 ip 192.168.8.29 -
sets the IP address to 192.168.8.29.
Routing Server> ether 1 netmask 192.168.8.29 -
sets the netmask to 192.168.8.29.
Sample Display:
Sample for ether0 command:
Ethernet Port 0 Configuration
IP Address : 192.168.2.20
Subnet Mask: 255.255.255.0
Guidelines:
To change this IP address initially, see Chapter 3: Using the LCD front panel/
Setting IP address.