Quintum Technologies Call Routing Server User Manual
Page 41
P/N 480-0028-00-00
5-4
Chapter 5: Configure via Command Line Interface (CLI)
gateway
ntpserver
Description:
Enables you to configure the default IP gateway, as well as display the current
default IP gateway.
When the unit is initially shipped, the IP address is set to 0.0.0.0.
Cmd Type:
Command.
Prompt Level:
Main Routing Server prompt.
Syntax:
gateway. Displays the current default IP gateway.
gateway {ipaddress}. Default gateway IP address that you enter.
Availability:
All Releases of Tenor Routing Server
Examples:
Routing Server> gateway. Displays as follows:
Default Gateway IP Address : 192.168.2.1
Routing Server> gateway 192.170.8.20 -
sets the default IP gateway to IP address to
192.170.8.20.
Guidelines:
To change this IP address initially, Chapter 3: Using the LCD front panel/Setting
IP address.
Description:
Enables you to configure the Network Time Protocol (NTP) Server IP address,
as well as display the current NTP Server IP address.
When the unit is initially shipped, the NTPServer IP address is set to 0.0.0.0.
Cmd Type:
Command.
Prompt Level:
Main Routing Server prompt.
Syntax:
ntpserver. Displays the current NTP Server IP address.
ntpserver {ipaddress}. Default NTP Server IP address that you enter.
Availability:
All Releases of Tenor Routing Server
Examples:
Routing Server> ntpserver. Displays as follows:
Network Time Protocol (NTP) Server: 130.126.24.24
Network Time Protocol (NTP) Server: 140.221.9.20
Routing Server> ntpserver 192.170.8.20 -
sets the NTP Server IP address to
192.143.8.20.
Guidelines:
To change this IP address initially, you will need to connect to the Tenor via
serial cable.