Teac MX-2424 v1.04 - Manual (Page 12)

REAR PANEL
The back panel is where all connections are made and user-installable modular I/O options may be installed. The
internal auto-switching power supply provides both 110 and 220 volt operation. For installation instructions of any
optional I/O modules please refer to MX-2424 Installation.
[53] Analog to Digital/Digital to Analog Module
The A/D/D/A module provides 24 channels of analog to digital and digital to analog conversion at 24 bit 44.1k/48k
or 12 channels of 24 bit 96k on six DB-25 connectors. All converters used are the same to ensure consistent high
quality audio across the entire machine.
[52] Digital I/O Options
There are three different 24 track digital options for the MX-2424: TDIF, ADAT Optical, and AES/EBU. The
AES/EBU module supports input sample rate conversion.
[55] AES/EBU Connectors
AES/EBU Female Connector:
This connector allows the input of AES/EBU stereo digital audio, which can then be routed to any odd/even pair of
tracks. Sample rate conversion may be applied to audio coming in on this connector.
AES/EBU digital clock may be received by the MX-2424 on this input as needed.
AES/EBU Male Connector:
This connector will output stereo AES/EBU digital audio and clock from a selectable stereo pair of adjacent
odd/even tracks. The default setting is clock only.
[54] S/PDIF Connectors
S/PDIF Coaxial Input Connector:
This connector allows the input of S/PDIF stereo digital audio, which can then be routed to any odd/even pair of
tracks. Sample rate conversion may be applied to audio coming in on this connector.
S/PDIF digital clock may be received by the MX-2424 this input as needed.
S/PDIF Coaxial Output Connector:
This connector will output stereo S/PDIF digital audio and clock from a selectable stereo pair of adjacent odd/even
tracks. The default setting is clock only.
[58] Remote Connector
This connector is used to connect the RC-2424 remote control unit. (Do not confuse this connector with the TL-Bus
connectors!)
[56} Footswitch
This connector allows the use of a foot switch for Record Punch In/Out. The MX-2424 will sense the polarity of the
footswitch when the unit is powered on with the footswitch connected. (Do not hold down the footswitch during
power up as this will cause the MX-2424 to incorrectly sense the polarity.) See MX-2424 Installation for details on
supported types of footswitches.
This connector will also accept input from an Alesis LRC for basic transport control.
12