Teac MX-2424 v1.04 - Manual (Page 26)

Pressing NEXT [76] will locate the Play Head to the beginning of the next audio event boundary on any track. If a
track is in Edit mode then only that track’s audio event boundaries will be used by this function. When using this
function <SHIFT> [19] will stay lit allowing additional NEXT operations without the need to press <SHIFT> [19]
again.
Pressing <SHIFT> [19] then NEXT<SYNCP> [76] will provide access the Slave Machine Sync Point Memory
Location. (For more information please see the TL-Sync Manual.)
IN/OUT
[30, 31] From the MX-2424
Pressing IN [30] or OUT [31] will cause the MX-2424’s Play Head to locate to the In or Out point and stop.
Pressing CAPT [16] then IN [30] or OUT [31] will place the time code location of the Play Head at the time
CAPT [16] was pressed into the In or Out memory locations. As soon as the capture key is pressed, the time code
value is captured and ready to store. CAPT [16, 71] may be pressed repeatedly, continually updating the captured
value until a target is determined.
If multiple units are on the TL-Bus and an In/Out point is set on any machine on the bus (slave or master), the
In/Out point will be updated on all machines that are active on the TL-Bus. Any offsets are taken into account for
each machine.
Pressing STORE [20] then IN [30] or OUT [31] will store the time code displayed in the bottom of the LCD into
the In or Out memory location.
Pressing RCL [21] then IN [30] or OUT [31] will recall the In or Out memory location into the bottom of the LCD
[18] for viewing or editing
[69, 70] From the RC-2424
Pressing IN [69] or OUT [70] will cause the MX-2424’s Play Head to locate to the In or Out point and stop.
Pressing CAPT [16,71] then IN [69] or OUT [70] will place the time code location of the Play Head at the time
CAPT [16,71] was pressed into the In or Out memory locations. As soon as the capture key is pressed, the time
code value is captured and ready to store. CAPT [16, 71] may be pressed repeatedly, continually updating the
captured value until a target is determined.
If multiple units are on the TL-Bus and an In/Out point is set on any machine on the bus (slave or master), the
In/Out point will be updated on all machines that are active on the TL-Bus. Any offsets are taken into account for
each machine.
Pressing STORE [20] then IN [69] or OUT [70] will store the time code displayed in the bottom of the LCD into
the In or Out memory locations.
Pressing RCL [21] then IN [69] or OUT [70] will recall the In or Out memory locations into the bottom of the
LCD [18] for viewing or editing
26