Verilink SCC 2020 (880-503268-001) Product Manual - Manual (Page 24)

Configuration
3-2 Verilink SCC 2020 User Manual
Verilink provides a cable called a "Craft cable" which has an RJ-11
modular connector at one end and a female DB-25 connector at the
other. Connect the RJ-11 modular connector to the port labeled
CRAFT on the front of the SCC 2020 module.
The Craft cable pinout is as follows:
Table 3-1 DB-25 Craft Cable p/n 458-501788-008
Your computer may have a DB-9 connector, requiring a second
cable or adapter to complete the connection. For this purpose, use
the same type of standard PC AT serial cable as would be used to
connect to an external modem.
An alternative Craft cable uses DB-9 and RJ-11 connectors. It is
wired according to the pinout shown below:
Table 3-2 DB-9 Craft Cable p/n 458-102119-008
Logging On The first thing you will see after connecting your terminal and
hitting the E
NTER key is:
pSH+> pSH+> pSH+> pSH+>
Certain TCP/IP and UNIX commands are available from this prompt
(ping, FTP, mv, rm, ls).
Most often you will want to use the Craft interface. To reach the
Craft interface from the pSH+> prompt, type the word “craft” in
lowercase:
pSH+> pSH+> pSH+> pSH+> craft
Then you'll see the password prompt:
YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD? YOUR PASSWORD?
Initially there is no password, so just press E
NTER again.
The top or Main Menu is displayed.
DB-25 female RJ-11 modular Usage
pin 2 pin 3 Transmit Data
pin 3 pin 4 Receive Data
pin 7 pin 5 Signal Ground
DB-9 female RJ-11 modular Usage
pin 3 pin 3 Transmit Data
pin 2 pin 4 Receive Data
pin 5 pin 5 Signal Ground