Verilink SCC 2020 (880-503268-001) Product Manual - Manual (Page 27)

Configuration
Verilink SCC 2020 User Manual 3-5
Figure 3-2 CSU Configuration Menu
Configuration
Menu Commands
Some of the commands on the CSU Configuration Menu are shown
on both the left and right sides of the screen. Commands that are
used for both DSX-1 equipment and T1 network ports are repeated
on both the equipment and the net side of the diagram. Command
prompts for these options present pairs of values: the value for the
equipment side is followed by the value for the network side.
For example, if connecting a D4 (SF) channel bank to an ESF T1
circuit the SF,ESF framing selection would be used.
Table 3-4 below describes all of the SCC 2020 CSU Configuration
Menu options:
CSU CONFIGURATION -- FW Rev 1.6 HW Fab 0.8 Type TAC 2010 -- CSU CONFIGURATION -- FW Rev 1.6 HW Fab 0.8 Type TAC 2010 -- CSU CONFIGURATION -- FW Rev 1.6 HW Fab 0.8 Type TAC 2010 -- CSU CONFIGURATION -- FW Rev 1.6 HW Fab 0.8 Type TAC 2010 --
|-----------------------| |-----------------------| |-----------------------| |-----------------------|
-------<< eq <<-------| K) keep alive FAIS |-------<< net <<-------
-------<< eq <<-------| K) keep alive FAIS |-------<< net <<------- -------<< eq <<-------| K) keep alive FAIS |-------<< net <<------- -------<< eq <<-------| K) keep alive FAIS |-------<< net <<-------
W) framing ESF | T) alm thld DEF | W) framing ESF
W) framing ESF | T) alm thld DEF | W) framing ESF W) framing ESF | T) alm thld DEF | W) framing ESF W) framing ESF | T) alm thld DEF | W) framing ESF
F) format B8ZS | | F) format B8ZS
F) format B8ZS | | F) format B8ZS F) format B8ZS | | F) format B8ZS F) format B8ZS | | F) format B8ZS
J) jitt buf 40 BITS | | J) jitt buf 40 BITS
J) jitt buf 40 BITS | | J) jitt buf 40 BITS J) jitt buf 40 BITS | | J) jitt buf 40 BITS J) jitt buf 40 BITS | | J) jitt buf 40 BITS
R) eq crc PASS | | R) net crc PASS
R) eq crc PASS | | R) net crc PASS R) eq crc PASS | | R) net crc PASS R) eq crc PASS | | R) net crc PASS
Y) xcode yel OFF | | Y) xcode yel OFF
Y) xcode yel OFF | | Y) xcode yel OFF Y) xcode yel OFF | | Y) xcode yel OFF Y) xcode yel OFF | | Y) xcode yel OFF
M) distance 0-133 | | L) lbO 0 DB
M) distance 0-133 | | L) lbO 0 DB M) distance 0-133 | | L) lbO 0 DB M) distance 0-133 | | L) lbO 0 DB
------->> eq >>-------| I) idle code ONES |------->> net >>-------
------->> eq >>-------| I) idle code ONES |------->> net >>------- ------->> eq >>-------| I) idle code ONES |------->> net >>------- ------->> eq >>-------| I) idle code ONES |------->> net >>-------
|-----------------------| Z) density NONE
|-----------------------| Z) density NONE |-----------------------| Z) density NONE |-----------------------| Z) density NONE
X) exit menu C1-C5) canned config X) exit menu C1-C5) canned config X) exit menu C1-C5) canned config X) exit menu C1-C5) canned config
V) Inband Management Commands ACCEPT
V) Inband Management Commands ACCEPT V) Inband Management Commands ACCEPT V) Inband Management Commands ACCEPT
A) diu bus A B) diu clock INT A) diu bus A B) diu clock INT A) diu bus A B) diu clock INT A) diu bus A B) diu clock INT
P) prm OFF O) poll far end OFF
P) prm OFF O) poll far end OFF P) prm OFF O) poll far end OFF P) prm OFF O) poll far end OFF
G) Alarm ENABLE G) Alarm ENABLE G) Alarm ENABLE G) Alarm ENABLE
[1,2] NEAR TAC 2010 >
[1,2] NEAR TAC 2010 > [1,2] NEAR TAC 2010 > [1,2] NEAR TAC 2010 >