Verilink SCC 2020 (880-503268-001) Product Manual - Manual (Page 36)

Configuration
3-14 Verilink SCC 2020 User Manual
Figure 3-5 Modem Configuration Menu
Modem
Configuration
Options
The Modem Configuration Menu is used to support an optional
dial-up modem which may be connected to the port labelled
Management Port In on the rear connector module. This port
supports the Serial Line Interface Protocol, a subset of TCP/IP
designed to support Internet protocols across a low-speed RS-232
Wide Area Network connection.
The Modem Status field on the Modem Configuration Menu
reflects the status of the Data Carrier Detect lead (DCD) on the
Management Port In.
If SLIP is used, it may be used with or without a modem. To use SLIP
without a modem, be certain that the Answer and Dial-Out fields
are set to DISABLED.
The options on the Modem Configuration Menu are documented
in
Table 3-6 below.
---- Modem Configuration ---- ---- Modem Configuration ---- ---- Modem Configuration ---- ---- Modem Configuration ----
Modem Status: NOT CONNECTED Modem Status: NOT CONNECTED Modem Status: NOT CONNECTED Modem Status: NOT CONNECTED
D) Answer : DISABLED D) Answer : DISABLED D) Answer : DISABLED D) Answer : DISABLED
C) Answer Command : AT &C1&D2&Q0 S0=1
C) Answer Command : AT &C1&D2&Q0 S0=1 C) Answer Command : AT &C1&D2&Q0 S0=1 C) Answer Command : AT &C1&D2&Q0 S0=1
T) Answer Inactive Timeout : 0 seconds
T) Answer Inactive Timeout : 0 seconds T) Answer Inactive Timeout : 0 seconds T) Answer Inactive Timeout : 0 seconds
B) Dial-Out : DISABLED B) Dial-Out : DISABLED B) Dial-Out : DISABLED B) Dial-Out : DISABLED
U) Dial-Out Command : AT &C1&D2&K3&Q0 X4 S0=0 DT
U) Dial-Out Command : AT &C1&D2&K3&Q0 X4 S0=0 DT U) Dial-Out Command : AT &C1&D2&K3&Q0 X4 S0=0 DT U) Dial-Out Command : AT &C1&D2&K3&Q0 X4 S0=0 DT
N) Dial-Out Number :
N) Dial-Out Number : N) Dial-Out Number : N) Dial-Out Number :
R) Dial-Out connect retries : 0
R) Dial-Out connect retries : 0 R) Dial-Out connect retries : 0 R) Dial-Out connect retries : 0
K) Dial-Out connect timeout : 60 seconds
K) Dial-Out connect timeout : 60 seconds K) Dial-Out connect timeout : 60 seconds K) Dial-Out connect timeout : 60 seconds
I) Dial-Out Inactive timeout : 0 seconds
I) Dial-Out Inactive timeout : 0 seconds I) Dial-Out Inactive timeout : 0 seconds I) Dial-Out Inactive timeout : 0 seconds
S) Dial-Out W) Set default commands S) Dial-Out W) Set default commands S) Dial-Out W) Set default commands S) Dial-Out W) Set default commands
A) Answer H) Hangup
A) Answer H) Hangup A) Answer H) Hangup A) Answer H) Hangup
X) exit
X) exit X) exit X) exit
[1,1] NEAR TAC 2010 > [1,1] NEAR TAC 2010 > [1,1] NEAR TAC 2010 > [1,1] NEAR TAC 2010 >