User-supplied tools and equipment – H3C Technologies H3C S9500E Series Switches User Manual
Page 33
23
Item Quantity
Purpose
ST2.9*9.5 self-tapping screw
1 set
Fixing the cable management brackets to the
mounting brackets (excluding the S9508E-V)
Air deflector
1 (supplied with the
S9508E-V only)
Installed at the rear of the switch to block air
from entering the chassis
ESD-preventive wrist strap 1
ESD-prevention
NOTE:
The number of screws and nuts supplied with the switch depend on those shipped from the factory.
User-supplied tools and equipment
•
Mechanical lift
•
Phillips screwdriver P1 – 100 mm, P2 – 150 mm, and P3 – 250 mm
•
Flat screwdriver P4 – 75 mm
•
Marker
•
Tape
•
Diagonal pliers, wire-stripping pliers, and wire clippers
•
Cables such as network cables and fiber cables
•
Meters and equipment such as HUB and multimeter
•
Configuration terminal
NOTE:
The rack accessories and installation tools are not included in this section. The accessories and installation
tools may vary depending on the rack model. For more information, see the installation guide of the
corresponding rack.