HEIDENHAIN TNC 640 (34059x-05) ISO programming - Manual (Page 197)

Tool data 5.2
5
TNC 640 | User's ManualDIN/ISO Programming | 1/2015
197
Deleting marked tool data
Using this function you can simply delete tool data that you no
longer need.
Follow the steps outlined below for deleting:
In the tool management you use the arrow keys or mouse to
mark the tool data that you wish to delete
Select the
DELETE MARKED TOOLS soft key and the TNC shows
a pop-up window listing the tool data to be deleted
Press the
START soft key to start the delete process: The TNC
shows the status of the delete process in a pop-up window
Terminate the delete process by pressing the
END key or soft
key
The TNC deletes all the data of all the tools
selected. Make sure that you really no longer
need the tool data, because there is no Undo
function available.
You cannot delete the tool data of tools still stored
in the pocket table. First remove the tool from the
magazine.