HEIDENHAIN TNC 640 (34059x-05) ISO programming - Manual (Page 75)

Modes of Operation 2.3
2
TNC 640 | User's ManualDIN/ISO Programming | 1/2015
75
Program Run, Full Sequence and Program Run,
Single Block
In the Program run full sequence mode of operation the TNC
executes a program continuously to its end or to a manual
or programmed stop. You can resume program run after an
interruption.
In the
Program run single block mode of operation you execute
each block separately by pressing the machine START button. With
point pattern cycles and
CYCL CALL PAT, the control stops after
each point.
Soft keys for selecting the screen layout
Soft key Window
Program
Left: program, right: status display
Left: program, right: graphics
Graphic
Left: program, right: collision object
Collision body
Soft key Window
Pallet table
Left: program, right: pallet table
Left: pallet table, right: status display
Left: pallet table, right: graphics