HEIDENHAIN TNC 640 (34059x-05) ISO programming - Manual (Page 603)

Configure HR 550 FS wireless handwheel 18.13
18
TNC 640 | User's ManualDIN/ISO Programming | 1/2015
603
18.13 Configure HR 550 FS wireless
handwheel
Application
Press the SET UP WIRELESS HANDWHEEL soft key to configure
the HR 550 FS wireless handwheel. The following functions are
available:
Assigning the handwheel to a specific handwheel holder
Setting the transmission channel
Analyzing the frequency spectrum for determining the optimum
transmission channel
Select transmitter power
Statistical information on the transmission quality
Assigning the handwheel to a specific handwheel
holder
Make sure that the handwheel holder is connected to the
control hardware.
Place the wireless handwheel you want to assign to the
handwheel holder in the handwheel holder
Press the
MOD key to select the MOD function
Select the Machine settings menu
Select the configuration menu for the wireless handwheel:
Press the
SET UP WIRELESS HANDWHEEL soft key
Click the Connect HR button: The TNC saves the serial number
of the wireless handwheel located in the handwheel holder and
shows it in the configuration window to the left of the
Connect
HR button
To save the configuration and exit the configuration menu, press
the
END button