HEIDENHAIN TNC 640 (34059x-05) ISO programming - Manual (Page 634)

Tables and overviews
19.4 Overview tables
19
634
TNC 640 | User's ManualDIN/ISO Programming | 1/2015
M Effect Effective at block... Start End Page
M97
Machine small contour steps ■ 357
M98 Machine open contours completely ■ 358
M99 Blockwise cycle call ■ Cycles
Manual
M101
M102
Automatic tool change with replacement tool if maximum tool life has
expired
Reset M101
■
■
186
M107
M108
Suppress error message for replacement tools with oversize
Reset M107
■
■
186
M109
M110
M111
Constant contouring speed at cutting edge (feed rate increase and
reduction)
Constant contouring speed at cutting edge (only feed rate reduction)
Reset M109/M110
■
■
■
361
M116
M117
Feed rate in mm/min on rotary axes
Reset M116
■
■
436
M118
Superimpose handwheel positioning during program run ■ 364
M120 Pre-calculate the radius-compensated contour (LOOK AHEAD) ■ 362
M126
M127
Shorter-path traverse of rotary axes:
Reset M126
■
■
437
M128
M129
Maintaining the position of the tool tip when positioning with tilted axes
(TCPM)
Reset M128
■
■
439
M130 Within the positioning block: Points are referenced to the untilted
coordinate system
■ 356
M138 Selection of tilted axes ■ 442
M140
Retraction from the contour in the tool-axis direction ■ 366
M143 Delete basic rotation ■ 369
M144
M145
Compensating the machine’s kinematic configuration for ACTUAL/
NOMINAL positions at end of block
Reset M144
■
■
443
M141 Suppress touch probe monitoring ■ 368
M148
M149
Automatically retract tool from the contour at an NC stop
Reset M148
■
■
370