HEIDENHAIN TNC 640 (34059x-05) ISO programming - Manual (Page 509)

Using 3-D touch probes 15.7
15
TNC 640 | User's ManualDIN/ISO Programming | 1/2015
509
15.7 Using 3-D touch probes
Overview
The following touch probe cycles are available in the Manual
Operation mode:
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC must be specially prepared by the machine
tool builder for the use of a 3-D touch probe. Refer to
your machine manual.
Soft key Function Page
Calibrating the 3-D Touch Probe 517
Measuring a 3-D basic rotation by
probing a plane
525
Measuring a basic rotation using
a line
524
Setting a datum in any axis 527
Setting a corner as datum 528
Setting a circle center as datum 529
Setting the centerline as datum 531
Touch probe system data
management
See User’s
Manual for
Cycles