Yaskawa Portable Control Display Unit - Manual (Page 67)

7 FORCING MENU
61 Forcing (FRC) Menu
01/22/96
• Pressing the ENT key will accept the
data in the display. The PCDU will
display the value just entered:
(NUMI PAC BLOCK)
(LOGO PAC BLOCK)
OR
• After the ENT key, press the ESC
key to obtain the following display:
• Remember that to activate the
Forcing mode the F2 key must be
pressed, and the “ F2 = FORCE ”
will flash. If normal values are to
be used, F3 should be selected, and
the “ F3 = NORM ” will flash.
• Pressing the CLR key will erase the
new data for the selected block,or
revert back to its original selected
state for logical blocks:
(NUMI PAC BLOCK)
(LOGO PAC BLOCK)
OR
LOGO Block 00444
OFF
NUMI Block 00200
F1 = Set New Val
F2 = Force
F3 = NORM
LOGO Block 00444
ON
NUMI Block 00200
100