Enterasys Networks 8000/8600 - Manual (Page 40)

Hardware Overview
28 Enterasys X-Pedition 8000/8600 Getting Started Guide
SSR-GLX39-02
The SSR-GLX39-02 (T-Series) line card provides the same features as the SSR-GSX31-02 line
card, but supports single mode fiber (SMF) as well as multimode fiber (MMF).
Figure 10 shows the
front panel of the SSR-GLX39-02 (T-Series) line card.
Figure 10. Front panel of SSR-GLX39-02 (T-Series) line card
LEDs
2 1
Link Offline
Online
Tx
Rx
1000BASE-LX SSR-GLX39-02
Hot
Swap
Link Tx
Rx AN AN
Gigabit Port Gigabit Port
Table 5. SSR-GLX39-02 line card LED Indicators
LED Condition Status
Offline Amber The line card is offline (powered off) but is ready for hot
swap.
The Offline LED also lights briefly during a reboot or
reset of the X-Pedition but goes out as soon as the control
module discovers the line card.
Online Green The line card is online and is ready to receive, process,
and send packets if configured to do so.
Per-port Link Green The port hardware detects a cable plugged into the port
and a good link is established.
Red (intermittent) The port received an error during operation.
Red (solid) The port hardware detects a cable plugged into the port,
however, a bad link is established.
Off Indicates that no link from the port exists.
Per-port Rx Green The port’s transceiver received a packet.
Amber The port’s transceiver received a flow control packet.
Per-port Tx Green The port’s transceiver transmitted a packet.
Amber The port’s transceiver transmitted a flow-control packet.