Enterasys Networks 8000/8600 - Manual (Page 92)

Installing the Hardware
80 Enterasys X-Pedition 8000/8600 Getting Started Guide
Installing the ATM PHY Cards
Each ATM line card has two slots available for PHY cards. One ATM PHY card can be installed
into each available slot. You will need a #2 Phillips screwdriver to perform this procedure.
Figure 35 shows an example of how to install a PHY card. The procedure following the figure
describes how to do this.
Figure 35. Installing an ATM PHY card
To install a PHY card into an ATM line card:
1. Use a Phillips screwdriver to loosen the two captive screws that hold the option slot cover in
place.
2. Save the option slot cover.
3. Hold the PHY card by the edges and position it so that it is parallel with the slot opening.
4. Insert the PHY card through the opening in the system unit by aligning the sides of the PHY
card with the card guide.
ATM Board
Seat screws into
mounting holes,
then press PHY card
to fully engage connector
Phy Card
Guide Rails