Cli setup, Proper boot sequence, Common errors – Enterasys Networks 8000/8600 User Manual
Page 87: Helpful cli commands for debugging
Enterasys X-Pedition 8000/8600 Getting Started Guide
75
Installing the Hardware
SSR-POS29-04
SSR-POS21-04
9.0.0.2
Note: If your system uses a redundant power
configuration or only one power supply, you
will not be able to support more than 5 cards
in the X-Pedition 8000 and 10 in the
X-Pedition 8600.
CLI Setup
Enter the following commands at the CLI before
implementing any configurations.
1.
Enable —> Configure —> <Enter>.
2.
Once you reach the configuration prompt, you
can configure the SSR-POS21-04 or
SSR-POS29-04 using CLI commands as
described in the X-Pedition CLI manual. Enter
the ? character to view the options available to
you in configuration mode.
Proper Boot Sequence
•
Offline LED lights at power-up.
•
Port LEDs flicker briefly during system boot while
ports initialize.
•
Online LED turns on once module is active.
Common Errors
•
The X-Pedition is not powered up.
•
The module is not properly seated in the slot.
•
Connectors on both ends of the cable are not properly
engaged. The copper cable did not click into place or
is not properly seated.
Helpful CLI Commands for Debugging
•
System show hardware
•
System show version
•
System show bootlog
SSR-POS39-02
SSR-POS31-02
9.0.0.2
Note: If your system uses a redundant power
configuration or only one power supply, you
will not be able to support more than 5 cards
in the X-Pedition 8000 and 10 in the
X-Pedition 8600.
CLI Setup
Enter the following commands at the CLI before
implementing any configurations.
1.
Enable —> Configure —> <Enter>.
2.
Once you reach the configuration prompt, you
can configure the SSR-POS39-02 or
SSR-POS31-02 using CLI commands as
described in the X-Pedition CLI manual. Enter
the ? character to view the options available to
you in configuration mode.
Proper Boot Sequence
•
Offline LED lights at power-up.
•
Port LEDs flicker briefly during system boot while
ports initialize.
•
Online LED turns on once module is active.
Common Errors
•
The X-Pedition is not powered up.
•
The module is not properly seated in the slot.
•
Connectors on both ends of the cable are not properly
engaged. The copper cable did not click into place or
is not properly seated.
Helpful CLI Commands for Debugging
•
System show hardware
•
System show version
•
System show bootlog
Table 19. Line card installation notes (Continued)
Minimum
Firmware
Restrictions
Special Instructions