Enterasys Networks 8000/8600 - Manual (Page 88)

Installing the Hardware
76 Enterasys X-Pedition 8000/8600 Getting Started Guide
SSR-SERC-04-AA E8.3.0.0 CLI Setup
Enter the following command at the CLI before
implementing any configurations.
1. Type the following from Enable mode to enter
Configuration mode
Enable -> Configure #
2. You may now begin configuring ports on the
SSR-SERC-04-AA. Refer to the Enterasys
X-Pedition Command Line Interface Reference
Manual for details.
Proper Boot Sequence
• Firmware loads.
• The control module for the chassis should indicate
that the SSR-SERC-04-AA was detected and is
operating correctly.
• The Online LED will turn on and remain lit (no other
LEDs should illuminate during module power-up).
Common Errors
• The ER16-SERC-04-AA is not inserted properly or
seated completely in the chassis
• Connectors for the connected lines are not seated
properly.
Helpful CLI Commands for Debugging
• System show hardware
• System show version
• Port show port status se.x.y (where x is the chassis
slot that contains the line card and y is a specific port
number on the card).
• System show bootlog
SSR-SERCE-04-AA E8.3.0.0 CLI Setup
Enter the following command at the CLI before
implementing any configurations.
1. Type the following from Enable mode to enter
Configuration mode
Enable -> Configure #
2. You may now begin configuring ports on the
SSR-SERCE-04-A. Refer to the Enterasys
X-Pedition Command Line Interface Reference
Manual for details.
Proper Boot Sequence
• Firmware loads.
• The control module for the chassis should indicate
that the SSR-SERCE-04-A was detected and is
operating correctly.
• The Online LED will turn on and remain lit (no other
LEDs should illuminate during module power-up).
Common Errors
• The ER16-SERCE-04-A is not inserted properly or
seated completely in the chassis
• Connectors for the connected lines are not seated
properly.
Helpful CLI Commands for Debugging
• System show hardware
• System show version
• Port show port status se.x.y (where x is the chassis
slot that contains the line card and y is a specific port
number on the card).
• System show bootlog
Table 19. Line card installation notes (Continued)
Minimum
Firmware Restrictions Special Instructions