Enterasys Networks 8000/8600 - Manual (Page 49)

Enterasys X-Pedition 8000/8600 Getting Started Guide 37
Hardware Overview
SSR-GSX31-02
The SSR-GSX31-02 line card contains two independent Gigabit (1000 Mbps) Ethernet ports. The
ports connect to multimode fiber (MMF) cables.
Figure 14 shows the front panel of the SSR-
GSX31-02 (T-Series) line card.
Figure 14. Front panel of SSR-GSX31-02 (T-Series) line card
LEDs.
2 1
Link Offline
Online
Tx
Rx
1000BASE-SX SSR-GSX31-02
Hot
Swap
Link Tx
Rx AN AN
Gigabit Port Gigabit Port
Table 9. SSR-GSX31-02 line card LEDs
LED Condition Description
Offline Amber The line card is offline (powered off) but is ready for hot
swap.
The Offline LED also is lit briefly during a reboot or reset of
the X-Pedition but goes out as soon as the control module
discovers the line card.
Online Green The line card is online and is ready to receive, process, and
send packets if configured to do so.
Per-port Link Green The port hardware detects a cable plugged into the port and a
good link is established.
Red
(intermittent) The port received an error during operation.
Red (solid) The port hardware detects a cable plugged into the port,
however, a bad link is established.
Off No link from the port exists.
Per-port Rx Green The port’s transceiver received a packet.
Amber The port’s transceiver received a flow-control packet.
Per-port Tx Green The port’s transceiver transmitted a packet.
Amber The port’s transceiver transmitted a flow-control packet.