Rose Electronics UltraConsole Remote 2 - Manual (Page 38)

INSTALLATION
32 ULTRACONSOLE REMOTE 2 INSTALLATION AND OPERATIONS MANUAL
Switch Installation – Single Unit
The basic installation of a single UltraConsole Remote 2 is an easy and straightforward procedure. Perform the
below steps for all computers that will be connected. It is recommended that all computers be powered off. When a
computer is connected and then booted, the UltraConsole Remote 2 will automatically determine the keyboard and
mouse types used for that computer and no pre-configuration is needed.
The connection to the network can be done at this time but it is not necessary to install a single unit.
The Unit above can be any UltraConsole Remote 2 model
If removing power from a computer is not practical, pre-configure the UltraConsole Remote 2 to define that CPU
port’s keyboard and mouse types. This procedure should only be done if the CPUs keyboard and mouse can be
disconnected and re-connected without affecting the interface.
The default keyboard type is PC mode 2, and the default mouse type is PS/2. If the computer being connected, with
power applied, uses a PC2 keyboard and PS/2 mouse, no pre-configuration is needed. If not, pre-configure the
keyboard and mouse types for that CPU port before connecting the computer (steps 6a-6e).
Please refer to the safety section before installation