Rose Electronics UltraConsole Remote 2 - Manual (Page 59)

ULTRACONSOLE REMOTE 2 INSTALLATION AND OPERATIONS MANUAL 53
Appendix C – Rack mounting
The rack mount kit includes the following items:
 Two black anodized mounting brackets
 Four 6 - 32 x 3/8” flat head mounting screws
To rack mount your UltraConsole Remote 2, attach the two rack mounting brackets to your Unit with the short flange
against the Unit using the four screws provided. Secure the mounting brackets to the rack using the appropriate size
bolts, nuts and lock washers. Using hardware other than that provided could cause damage to the electronics and/or
result in loss of mounting integrity. Do not over tighten the screws used to mount the Unit to the mounting brackets.
The following general guidelines should be observed when installing your Unit into a rack.
a).
The UltraConsole Remote 2 is designed to work in an ambient temperature of 0
ο
C to 45
ο
C (32
ο
F – 113
ο
F).
b). Do not block power supply vents or otherwise restrict airflow when rack-mounting this Unit.
c). Mechanical loading of the rack should be considered to prevent instability and possible tipping over.
d). Tighten all connectors securely and provide adequate strain relief for all cables.
e). Provide a grounded power source to all Units. Pay special attention to overall branch circuit load ratings before
connecting equipment to this source. Overloaded circuits are potential fire hazards and can cause equipment
failures or poor performance.
Rack mount illustration