Rose Electronics UltraMatrix Remote 2 - Manual (Page 13)

ULTRAMATRIX REMOTE 2 INSTALLATION AND OPERATIONS MANUAL 7
Connecting the Computers / Servers
Connect each computer to the UltraMatrix Remote 2 using the appropriate CPU adapter cable designed to interface to
the type of computer being connected (PS/2, Unix, SUN, DEC, Apple, etc). Connect the DB25M end of the CPU
adapter cable to the desired DB25F CPU port on the rear panel of the unit. Connect the other end of the cable to the
corresponding ports on the computer (keyboard, monitor, and mouse). Refer to Figure 3
Figure 3. Single Unit Installation (Computers)
Connecting to the network
Network cables should NOT be connected until the unit has been configured with the assigned IP addresses. The
default IP address may conflict with existing equipment on your network.
When the IP addresses have been assigned, connect a network cable(s) from the RJ45 connector(s) on the rear panel
of the UltraMatrix Remote 2 and to your network (See Figure 4).
Figure 4. Single Unit Installation (Network)
Remote
computer
connections
CPU adapter
cable(s)
Network connection