Rose Electronics UltraMatrix Remote 2 - Manual (Page 38)

32 ULTRAMATRIX REMOTE 2 INSTALLATION AND OPERATIONS MANUAL
Computers
Indicates the CPU port numbers for a given CPU card.
Highlighted computer numbers are the total computer ports in the system.
Power
Each CPU card represents 4 CPU ports. These ports are represented by the four squares. The CPU ports are (Left
square to right square), CPU port 1, port 2, port 3, and port 4. (Green = CPU is on, Red = CPU is off)
Pos (Position)
Displays the slot where a CPU card in the system is installed for a given switch. Slot 1 is the bottom CPU card; slot 2
is the top CPU card for the 2xE model, slot 4 is the top CPU card for the 4xE model.
Ver (Version)
Displays the last three digits of the firmware main program version for the CPU card.
KVM
Indicates the type of keyboard and mouse detected if a KVM station is attached to this CPU card.
CPU
Displays the computer number currently selected by the KVM station.
User
Displays the users name that is currently accessing the system.
Status
Displays the most recent connect or disconnect status for the KVM station on this CPU card.
Save menu
When changes are made to any configuration, they must be saved in flash memory to insure that the changes will be
active after a power cycle. It is recommended that all users be logged off from all systems prior to saving any
configuration changes.
Figure 28. Save menu
To save the settings, select save and press [Enter]. The UltraMatrix remote 2 will check and display how many CPU
cards in the system to update. This is the total number of CPU cards (RS232 ports) in the system not counting the one
the KVM station is connected to. (Total boards – 1)
A YES/NO selection box will display. Choose “YES” to save the changes to flash memory on all powered-on units.
Choose “NO” for temporary or incorrect changes. The temporary settings will only be in effect as long as power is
applied to the Unit. Once power is cycled, unsaved changes, other than the starting computer number, are lost and
the previously saved configuration settings will be effective.