Rose Electronics UltraMatrix Remote 2 - Manual (Page 57)

ULTRAMATRIX REMOTE 2 INSTALLATION AND OPERATIONS MANUAL 51
Misc.
Shared connection (do not disconnect other viewers)
This option does not apply to UltraMatrix Remote 2 unit.
Full screen mode
When ticked, the VNC viewer will launch in full screen mode.
Use the menu key (usually F8) to exit from full screen mode.
Full-screen mode matches server resolution
This option does not apply to UltraMatrix Remote 2 unit.
Full-screen mode uses all monitors
This option does not apply to UltraMatrix Remote 2 unit
Render cursor locally
This option does not currently apply to UltraMatrix Remote 2
unit.
Allow dynamic desktop resizing
When ticked, the viewer window will be automatically resized
whenever the host system’s screen resolution is altered.
Only use protocol version 3.3
This option does not apply to UltraMatrix Remote 2 unit.
Beep when requested to by the server
When ticked, your local system will beep in response to any
error beeps emitted by the UltraMatrix Remote 2.
Offer to automatically reconnect
When ticked, the viewer will offer to restore a lost connection
with the server.
Try Single Sign-On if server allows it
This option does not apply to UltraMatrix Remote 2 unit.
Enable file transfer
This feature does not apply to the UltraMatrix Remote 2 unit
installations.
Identities
This feature helps your VNC viewer to confirm that a revisited
UltraMatrix Remote 2 unit is genuine and not another device
masquerading as an UltraMatrix Remote 2. The list given will
retain the identities of all visited units (that have full security
enabled).
When you first make a secure connection to the UltraMatrix
Remote 2, the security information for that UltraMatrix Remote 2
unit is cached within this Identities tab (i.e. the “identity” is
known). The next time that you connect to the UltraMatrix
Remote 2 unit, its identity is checked against the stored version.
If a mismatch is found between the current and the stored
identities then a warning will be issued to you.
If an existing UltraMatrix Remote 2 unit is fully reconfigured then
it will need to be issued with a new identity. In this case the
previous identity, listed in this tab, should be removed so that a
new identity can be created on the next connection.