6 wiring the digital input / output, Do gnd – PLANET MGSD-10080F User Manual
Page 41
User’s Manual of MGSD-10080F
41
2.1.6 Wiring the Digital Input / Output
The 6-contact terminal block connector on the front panel of MGSD-10080F is used for Digital Input and Digital Output. Please
follow the steps below to insert wire.
1.
The MGSD-10080F offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups and 5 and 6 are GND
(ground).
Figure 2-5 Wiring the Redundant Power Inputs
2.
Tighten the wire-clamp screws for preventing the wires from loosening.
1
2
3
4
5
6
DI0
DI1 DO0 DO1 GND GND
Figure 2-6 6-Pin Terminal Block DI / DO Wiring Input
3.
There are two Digital Input groups for you to monitor two different devices. The following topology shows how to wire DI0
and DI1. We use the MGSD-10080F to be an example for describing DI application.
DI
DO GND