PLANET MGSD-10080F - Manual (Page 48)

User’s Manual of MGSD-10080F
48
MGB-LB40 SFP-Port 1000Base-L X ( W DM,TX:1550nm) mini-GBIC module-40km
MGB-TSX SFP-Port 1000Base-SX mini-GBIC module - 550m (-40~75 degrees C)
MGB-TLX SFP-Port 1000Base-LX mini-GBIC module - 10km (-40~75 degreesC)
MGB-TL30 SFP-Port 1000Base-LX mini-GBIC module - 30km (-40~75 degrees C)
MGB-TL70 SFP-Port 1000Base-LX mini-GBIC module - 70km (-40~75 degrees C)
Fast Ethernet SFP Transceiver Modules
MFB-FX SFP-Port 100Base-F X Tra nsceiver (1310nm)-2km
MFB-F20 SFP-Port 100Base-F X Tra nsceiver (1310nm)-20km
MFB-F40 SFP-Port 100Base-F X Tra nsceiver (1310nm)-40km
MFB-F60 SFP-Port 100Base-F X Tra nsceiver (1310nm)-60km
MFB-FA20 SFP-Port 100Base-B X Tra nsceiver (W DM, TX:1310n m)-20km
MFB-FB20 SFP-Port 100Base-B X Tra nsceiver (W DM, TX:1550n m)-20km
MFB-TFX SFP-Port 100Base-FX Transceiver (1310nm) -2km (-40~75 degrees C)
MFB-TF20 SFP-Port 100Base-FX Transceiver (1310nm) - 20km (-40~75 degrees C)
1. It is recommended to use PLANET SFPs on the Managed Switch. If you insert an SFP
transceiver that is not supported, the Managed Switch will not recognize it.
2. Please choose the SFP transceiver which can be operated under -40~75 degrees C
temperature if the switch device is working in an 0~50 degrees C temperature environment.
1000Base-SX/LX:
Before connecting the other switches, workstation or media converter.
1. Make sure both sides of the SFP transceiver are with the same media type, for example, 1000Base-SX to 1000Base-SX,
1000Bas-LX to 1000Base-LX.
2. Check the fiber-optic cable type that matches the SFP transceiver model.
 To connect to 1000Base-SX SFP transceiver, use the multi-mode fiber cable with one side being the male duplex LC
connector type.
 To connect to 1000Base-LX SFP transceiver, use the single-mode fiber cable with one side being the male duplex LC
connector type.
Connecting the fiber cable
1. Attach the duplex LC connector on the network cable into the SFP transceiver.
2. Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a media
converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP transceiver is
operating correctly.