PLANET WNAP-7206 - Manual (Page 24)

User Manual of WNAP-7206
-16-
3.4 Pole Mounting
Step 1. Turn the WNAP-7206 over. Put the pole mounting tie through the middle hole of it.
Step 2. Mount WNAP-7206 steadily to the pole by fastening the mounting tie tightly.
Step 3. Now you have completed the hardware installation of WNAP-7206 as figure below.
Figure 3-6 Pole Mounting
3.4.1 Using the External Antenna
If you prefer to use the external antenna with RP-SMA Type connector for your application instead of the built-in
directional antenna, please follow the steps below.
Step 1. Connect your antenna with the RP-SMA Type connector on the bottom of WNAP-7206.
Step 2. Power on the WNAP-7206, and then go to Wireless -> Wireless Advanced to configure the Antenna
Setting to “External Antenna”.
1. If you are going to use an external antenna on WNAP-7206, get some cable in
advance.
1. Users MUST power off the WNAP-7206 first before connecting the external
antenna to it. Do not switch from built-in antenna to the external antenna from
WEB management without physically attaching the external antenna onto the
WNAP-7206 ; otherwise, damage might be caused to the WNAP-7206 itself.