PLANET WNAP-7206 - Manual (Page 51)

User Manual of WNAP-7206
-43-
 Disabled
The Secondary Connection is disabled by default, so there is
PPPoE connection only. This is recommended.
 Dynamic IP
Use dynamic IP address to connect to the local area network
provided by ISP.
 Static IP (For Dual
Access/Russia PPPoE)
Use static IP address to connect to the local area network
provided by ISP.
Wan Connection Mode
 Connect on Demand
You can configure the Device to disconnect your Internet
connection after a specified period of the Internet connectivity
(Max Idle Time). If your Internet connection has been
terminated due to inactivity, Connect on Demand enables the
Device to automatically re-establish your connection when you
attempt to access the Internet again. If you wish to activate
Connect on Demand, put a check mark in the circle. If you
want your Internet connection to remain active all the time,
enter 0 in the Max Idle Time field.
Sometimes the connection cannot be disconnected although
you specify a time to Max Idle Time (0~99 mins) because some
applications visit the Internet continually in the background.
 Connect Automatically
Connect automatically after the Device is disconnected. To use
this option, click the radio button.
 Time-based
Connecting
You can configure the Device to make it connect or disconnect
based on time. Enter the start time in HH-MM for connecting
and end time in HH-MM for disconnecting in the Period of Time
fields.
 Connect Manually
You can configure the Device to make it connect or disconnect
manually. After a specified period of inactivity (Max Idle Time),
the Device will disconnect your Internet connection, and not be
able to re-establish your connection automatically as soon as
you attempt to access the Internet again. To use this option,
click the radio button. If you want your Internet connection to
remain active all the times, enter 0 in the Max Idle Time field.
Otherwise, enter the number in minutes that you wish to have
the Internet connecting last unless a new link is requested.
 Connect Click the Connect button to connect immediately.
 Disconnect Click the Disconnect button to disconnect immediately.
 Save Click the Save button to save your settings.