NEC M Series 32" Commercial PCAP Touchscreen Display - Manual (Page 79)

English−75
PICTURE MENU
COLOR
COLOR* 4 Adjusts the color saturation of the screen. Press + or – button to adjust.
COLOR TEMP: Adjusts the color temperature of the entire screen. A low color temperature will result in a reddish screen.
A high color temperature will make the screen bluish. If a temperature needs further adjustment, the
individual R/G/B/ levels of the white point can be adjusted. To adjust the R/G/B levels, set [CUSTOM] as
[COLOR TEMP] selection.
NOTE:
When [PROGRAMMABLE1], [PROGRAMMABLE2] or [PROGRAMMABLE3] is selected in
[GAMMA], this function cannot be changed.
COLOR CONTROL Adjusts the hue of the Red, Yellow, Green, Cyan, Blue and Magenta colors individually. For example, you
can change red to yellow or purple.
CONTRAST* 4 Adjusts the image brightness in relationship to the input signal. Press + or – button to adjust.
ADJUST
VGA(RGB) input only
AUTO SETUP Automatically adjusts Screen Size, H position, V position, Clock, Phase and White Level.
AUTO ADJUST [H POSITION], [V POSITION] and [PHASE] are adjusted automatically when new timing is detected.
NOTE:
Depending on the display card or drivers used, the image may not be adjusted correctly.
In this case, please run [AUTO SETUP], or individually set [H POSITION], [V POSITION],
[CLOCK], and [PHASE].
When [AUTO ADJUST] is [ON], if the screen position shifts repeatedly, please change the setting
to [OFF].
H POSITION Controls the horizontal position of the image within the display area of the LCD.
Press + button to move right. Press – button to move left.
V POSITION Controls the vertical position of the image within the display area of the LCD.
Press + button to move up. Press – button to move down.
CLOCK Press + button to expand the width of the image on the right of the screen.
Press – button to narrow the width of the image on the left of the screen.
PHASE Adjusts the visual “noise” in the image.
H RESOLUTION Adjusts the horizontal size of the image.
V RESOLUTION Adjusts the vertical size of the image.
ADVANCED
HDR MODE
HDMI input only
When the monitor detects an HDR signal, you can select preferred gamma correction from [LOW],
[MIDDLE] or [HIGH].
SHARPNESS* 4 Adjusts the crispness of the image. Press + or – button to adjust.
NOTE:
Depending on the combination of the input resolution and the [ASPECT] setting, this function may
not work.
ASPECT Select the aspect ratio of the screen image.
NOTE:
• If you change [H POS] and [V POS] settings with a reduced image, the image will not be
changed.
• The [ASPECT] automatically changes to [FULL] when the [SCREEN SAVER] starts. When the
[SCREEN SAVER] stops, the [ASPECT] returns to its previous setting.
• This function is not available when [MOTION] in [SCREEN SAVER] is active.
• [ZOOM] is not available for an image with an input resolution of 4K.
NORMAL Shows the aspect ratio as it is sent from the source.
FULL Fills the entire screen.
WIDE Expands a 16:9 letterbox signal to fill the entire screen.
1:1 Shows the image in a 1 by 1 Pixel format. (If the input resolution is higher than the recommended
resolution, the image will be scaled down to fit the screen).
ZOOM Expands/reduces the image.
NOTE:
The areas of the expanded image that are outside of the active screen area are not shown.
The reduced image may have some image degradation.
ZOOM Maintains the aspect ratio while zooming.
HZOOM Horizontal zoom value.
VZOOM Vertical zoom value.
H POS Horizontal position.
V POS Vertical position.