FujiFilm Quality Dry Photo Paper for Frontier-S DX100 Printer (Glossy, 4" x 213' Roll, 2-Pack) - Manual (Page 72)

Code Message What to do
W-1101 A paper jam has occurred.
Delete all print jobs remaining in the operating system's print
queue.
Remove any paper remaining from the roll paper feeder, and
then reload the paper.
After deleting all of the print jobs, remove
the paper from the roll paper feeder, and
then reload the paper.
U “Paper Jams” on page 77
W-1102 A paper jam has occurred.
Delete all print jobs remaining in the operating system's print
queue.
Open the rear cover and the top cover, remove any paper
remaining, and then reload the paper.
After deleting all of the print jobs, remove
the paper from the internal paper feeder,
and then reload the paper.
If the printer is setup so that you cannot
access the rear of the printer to perform
maintenance, contact service support.
U “Paper Jams” on page 77
W-1103 An error has occurred in the paper feeding unit.
Delete all print jobs remaining in the operating system's print
queue.
Reload the paper in the same way as when replacing paper.
After deleting all of the print jobs, check that
there is no paper inside the printer, and then
reload the paper. If a message is displayed,
check the details.
U “Replacing Paper” on page 23
W-1104 Paper is not loaded correctly.
Delete all print jobs remaining in the operating system's print
queue.
Check the position of the paper width guide, and then reload
the paper.
After deleting all of the print jobs, check that
there is no paper inside the printer, and then
reload the paper.
When loading the paper, match the inner
edge guide and the front edge guide to the
width of the paper. If a message is displayed,
check the details.
U “Replacing Paper” on page 23
W-1105 Paper is out.
Delete all print jobs remaining in the operating system's print
queue.
Load paper.
After deleting all of the print jobs, check that
there is no paper inside the printer, and then
reload the paper. If a message is displayed,
check the details.
U “Replacing Paper” on page 23
W-1106 Paper is out or not loaded correctly.
Delete all print jobs remaining in the operating system's print
queue.
Load paper.
W-1107 The loaded paper does not match the print settings.
Delete all print jobs remaining in the operating system's print
queue.
Change the print settings or the loaded paper, and then print.
If you click [OK] without deleting the print jobs, the jobs are
printed using the current settings.
After deleting all of the print jobs, load the
appropriate paper.
When replacing the paper, set the Paper
Type and the Paper Level in the
Maintenance Tool.
U “Replacing Paper” on page 23
W-1108 The width of the loaded paper is not supported.
Delete all print jobs remaining in the operating system's print
queue.
Load supported paper.
After deleting all of the print jobs, load the
appropriate paper.
U “Replacing Paper” on page 23
W-2401 Maintenance cartridge not installed
Delete all print jobs remaining in the operating system's print
queue.
Install the maintenance cartridge.
After deleting all of the print jobs, install the
maintenance cartridge correctly.
U “Replacing the Maintenance Cartridge”
on page 53
Frontier-S Operation Guide
Troubleshooting
72