Hearth and Home Technologies EPA Certified Woodburning Fireplace 7100FP-GD-B - Manual (Page 36)

Page 36 433-1390G September 1, 2008
R
7100FP EPA Woodburning Fireplace
Remove 2 screws and
pry open access door.
1. Remove both doors, fascia and brick.
2. Remove 2 Phillips head screws and pry open access
door in the bottom of the fireplace with a flat head screw-
driver. Figure 36.1.
E. Timer Assembly Replacement
3. Remove 2 screws and take off access cover. Figure
36.2.
NOTE: The timer assembly included in this kit comes
with the air chamber cover attached. Figure 36.3.
Figure 36.1 Open Access Door
Figure 36.2 Access Cover
Remove 2
screws
Air Chamber Cover is
attached to Timer Assembly
8/32 Screw installed back to
front and secured with a
lock nut
Figure 36.3 Timer Assembly with Air Chamber Cover
(Linkage arm is not included in the kit)
Figure 36.4
Figure 36.5
Move arm left
Be careful not to
drop Linkage Arm
down into fireplace
5. Remove 2 screws from timer linkage upper arm. Be
careful NOT TO DROP arm in bottom of fireplace. Figure
36.6.
Figure 36.6
4. You will need to disconnect air chamber cover from timer
assembly before installing in the fireplace. Set screws
aside for later use. Figure 36.4.
Shock Risk
Disconnect power by turning off circuit breaker
BEFORE servicing.
CAUTION
6. Remove 2 screws from timer mounting plate. Figure
37.1.